System Connection - Party Light & Sound PARTY-200UHF Manual De Instrucciones

MICROPHONE TRANSMITTER FEATURES
1. Grille: Protects the cartridge and helps reducing the
breath sounds and wind noise.
2. Power indicator
3. ON/OFF switch
4. Tail-hood to identify the mic
TRANSMITTER BATTERY INSTALLATION
Push the battery cover open. Insert 2x AA batteries into the
battery compartment with the correct polarity. Close the battery
cover.

SYSTEM CONNECTION

1. Receiver power connection: Connect the DC connector of the supplied AC/DC adaptor to the DC input socket on
the receiver. Plug the AC connector into an appropriate mains outlet.
2. Antenna: Keep the position of the antenna at an angle of 90°.
3. Audio connection: Connect the corresponding output of the receiver via a 6.35mm Jack lead or an XLR lead to the
input of a power amplifier, mixer, etc.
TIPS TO ACHIEVE MAXIMUM PERFORMANCE
Make sure you can always see the receiver antenna
from the transmitter position.
Keep the distance from transmitter to receiver antenna
as short as possible.
Avoid placing the receiver antennae near metal surfaces
and obstruction.
Monitor battery power and replace the battery as soon
as the red light goes on.
If stacking or rack mounting receivers in a multiple
system, do not allow antennae to touch or cross.
Perform a walk-through before performance or
presentation. If dead spots are found, adjust location of
the receiver. If dead spots remain, mark them and avoid
them during performance.
For a good operation, don't place the receiver near to sources of interference. Place the receiver in 1m distance from
the ground and let at least 1m free space around the receiver.
©Copyright Lotronic 2019 PARTY--200UHF 4