Mounting The Terminal; Connecting To Peripheral Components; Opening The Terminal Enclosure - Mettler Toledo IND310drive Manual De Instalación

Chapter 2.0
Installation
This chapter covers
•

Mounting the Terminal

•

Connecting to Peripheral Components

•
Power-up Sequence
Mounting the Terminal
Mount the terminal on any flat surface or wall where viewing is optimal and the
terminal keys are easily accessible. Observe location and environment considerations
as described in Chapter 1.0.
Mounting hole locations are shown in Figure 1-4. The diameter of the mounting holes
is 8 mm. The largest recommended bolt/screw size is M6.
Connecting to Peripheral Components

Opening the Terminal Enclosure

The front panel of the IND310drive terminal is locked in place by four spring clips
attached to the enclosure body. To gain access to the terminal's PCB for internal
wiring and setting switches, separate the front panel from the enclosure as follows:
1. Insert the tip of a flat-blade screwdriver into one of the two slots located on the
bottom of the front panel assembly (see Figure 2-1) and gently push in toward
the enclosure. A "pop" sound is made when the cover is released.
2. Repeat Step 1 for the other slot.
This chapter provides detailed instructions for installing the
IND310drive terminal. Please read this chapter thoroughly
before beginning installation.
Front Panel spring clip
removal slots (2)
Figure 2-1: IND310drive Terminal Access
2-1