Assembly Procedures - INVENTOR QLT-700 Manual Del Propietário

|Assembly Instructions

Assembly procedures

1
Take down the air inlet grill.
Grasp the clasp position and pull outward
to remove the air inlet grill.
2
Take out the Pre-Filter.
Press down and pull the U-shaped snap
joint, and take out the Pre-Filter.
3
Take out the HEPA Filter.
Hold both sides of the HEPA Filter with
both hands, and take out the HEPA Filter.
4
Remove the protective film of the
filter.
5
Assemble the HEPA Filter.
10
6
Assemble the Pre-Filter.
Align the slot position at the bottom, and
click into the upper U-shaped snap joint.
7
Assemble the air inlet grill.
Align with the slot position at the bottom,
press both sides of the upper part of the
air inlet grill, and clasp the air inlet grill.
8
Assemble the filter on the other side.
Repeat Steps 1-7 to assemble the filter on
the other side.
9
Install the caster
Tilt the machine body to install
the casters and press into 4
casters with force in turn at the
bottom.
10
Then power on for operation.
EN