Home Decorators Collection FELDNER 56055 Guía De Uso Y Mantenimiento página 10

Assembly - Hanging the Fan (continued)
5
Wiring the fan to the receiver
NOTE: The fan comes with 12 in. extension wires for use
with the provided 6 in. ball/downrod assembly (B). If you
wish to use a longer downrod, attach the extension wire
(K) to the fan by connecting the molded adaptor plugs
from the extension wires to the adaptor plugs from the
fan.
□
If using the 6 in. ball/downrod assembly (B) provided, wire the
receiver to the fan wires by connecting the molded adaptor
plug from the receiver (I) with the molded adaptor of the fan
motor assembly (E) together.
□
If you wish to use longer downrod, you can use the extension
wire (66 in.) (K) provided by connecting the molded adaptor
together.
6
Mounting the fan motor assembly
(standard mount)
WARNING: When using the standard ball/downrod
mounting, the tab in the ring at the bottom of the
mounting bracket must rest in the groove of the
hanger ball. Failure to properly seat the tab in the
groove could cause damage to the wiring.
NOTE: The magnet is pre-attached on the canopy bottom
cover for you to remove and install easily.
NOTE: For better performance with the Wi-Fi system, the
Wi-Fi antenna must be mounted to the ceiling outside of
the fan's ceiling canopy.
□
Align the locking slots of the canopy (C) with the two screws (FF)
and alignment post (OO) in the slide-on mounting bracket (A).
□
Push up the canopy (C) and turn it clockwise until the alignment
post (OO) engages to the round hole and the screws (FF) engage
to the key slots.
□
Firmly tighten the two mounting screws (FF).
□
Align the oval shape on the canopy (C) with canopy bottom cover
(JJ).
□
Push up the canopy bottom cover (JJ) until the screw (FF) heads
engage to the slots on the canopy bottom cover (JJ) so that
the magnetic canopy bottom cover (JJ) can be attached to the
bottom of the canopy (C) properly.
K
10
Outlet box
Green
OO
View after installation
WiFi antenna mount
outside of the canopy
A
FF
C
B
JJ
E