Publicidad
Idiomas disponibles
Idiomas disponibles
Specifications
General
BASIC PICCOLO:
* Power: 12VDC / 5A / 60 Watts.
* Driver protection: IP40.
* Sound Sensitivity: 15mV
REMOTE CONTROL:
* Reach: 30 meters without obstacles.
* Frequency: 433 MHz.
MODULE OUTPUT
* Basic Piccolo: 12VDC RGB common anode 60W - 5A Obs. Make sure that the 12V DC power supply supports the
current and power of the Pool Lights.
* Never use a source with a power or current greater than 60W - 5A.
FOR MORE DETAILS, SEE CONNECTION SCHEME.
The LED Light Controller is designed to operate 6 Pool Lights Super LED 9W or 2 Super Pool Lights Super LED
27W. The reflector wires should always be driven to a junction box; from there they could be taken directly to the
controller. You can also use a single set of wires to go from the junction box to the controller; in order to do this, it
is necessary to connect the wires with the same colors so that the reflectors are always color synchronized. After
connecting the matching colors, this main cable should be connected to the LED Light Controller. This cable must
have a maximum length of 20 meters and have the following specification: 3x22 AWG (red, green, blue) and 1x16
AWG (white).
Remote Control Registry
The remote control is factory configured for immediate use; it does not need any adjustments.
If it is necessary to replace the control, it must be previously programmed in the controller before using
it, otherwise, it will not work. To register a new Remote Control or reconfigure your Remote Control:
1- With the Reflectors off, press and release the "Effects" + "on/off" keys at the same time. The reflectors will
start to flash white. This will indicate that Basic Piccolo has entered remote control programming mode.
2- Press any key on the controller that you want to program. If the reflectors stop blinking, Basic Piccolo has recognized
the remote control and that's it, you already have a new remote control ready to command your controller functions.
3- Test all the buttons on the remote control and make sure that they all responded according to the functions of the
model purchased.
Delete all registered controls:
It is possible to delete all control saved, to do this, reset the controller memory:
- Press all the keys on the front of the panel for 3 seconds and wait for the Reflectors flash white twice.
- Turn the controller off and on again. If the first color that lights up when turned on is blue, it means that the reset
was successful.
Operation
CONTROLLER FUNCTIONS
The effects and colors are changed using the Button "Effects" on the front of the panel and the button (2) on
remote control. The colors and functions are always changed in the same order, in a single direction, that is, it is
not possible to return to the previous function, it is necessary to repeat the cycle until reaching the desired color
or effect.
Dimensions
BASIC PICCOLO:
* Approximate weight: 110g.
* Dimensions L x W x D: 80 x 55 x 26 mm.
MORE DETAILS SEE DIMENSIONAL.
REMOTE CONTROL:
* Approximate weight: 20g.
* Dimensions L x W x D: 34.16 x 61.16 x 12.35 mm.
5
Installation and User's Guide
Publicidad
