Publicidad
Idiomas disponibles
Idiomas disponibles
Operation
The intensity control is performed by the Button "Dimmer" on the front of the panel and the button (3) on the
remote control. The first time it is turned on, the lighting is set to maximum brightness and decreases as the button
Dimmer/3 is pressed. When the illumination reaches the minimum brightness, the reflector flashes white 3 times
to indicate to the user that the reflector has returned to its initial configuration.
Effects and colors:
1-Lighting with colorful strobe effect commanded
according to the rhythm of the music; (Note: to use the
audio effect you need a microphone with a p2 mono
connector - not included) (5 intensity levels).
2-Fixed color white (5 intensity levels).
3-Fixed color red (5 intensity levels).
4-Fixed color blue (5 intensity levels).
5-Fixed color green (5 intensity levels).
6-Fixed color magenta (5 intensity levels).
7-Fixed color light blue (5 intensity levels).
8-Fixed color yellow (5 intensity levels).
9-Fast color transition
10-Slow color transition
11-Lighting with white strobe effect
Wiring diagram
Controller
6
Installation and User's Guide
Illustrative image
12-Quick mix: Color change quick, in random mode
(White, Red, Blue, Green, Magenta, Light blue, Yellow)
(5 intensity levels).
13-Slow mix: Color change slow, in random mode
(White, Red, Blue, Green, Magenta, Light blue, Yellow)
(5 intensity levels).
The controller is energized in the 2-way connector.
To connect the controller to the Reflectos, just take
a 4-way cable (or 4-way sleeve cable) to the Junction
box closest to the pool, and from there make the
connections in parallel. This is to minimize the
amount of cables that will reach the controller.
* The common reflectors output is 12VDC (+) and the
RGB outputs will have 0V (-), indicated for reflectors
with a common cable type.
Publicidad
