Interlogix VE700AM Serie Manual De Instalación página 6

24
26
EN: Installation Manual
Introduction
The VE735AM and VE736AM are PIR-AM motion
sensors. They have a patented verified PIR
technology, with multi-channel anti-masking.
Installation guidelines
The technology in this detector resists false alarm
hazards. Nevertheless avoid potential causes of
instability, such as:
•
Direct sunlight on the detector
•
Heat sources within a field of view
•
Strong draughts onto the detector
•
Large animals in a field of view
•
Objects within 50 cm (20 in.) of the anti-
masking (AM) detector
6 / 80
25
• Obscuring the detector's field of view with large
objects, such as furniture
•
Installing two detectors facing each other and
less than 50 cm apart
Install the detector so that the expected movement
of an intruder will be across the fields of view (see
example in Figure 21, item 1). This is the direction
SB01
best detected by PIR detectors.
Mounting the detector
1. Lift off the custom insert and remove the
enclosed screw (Figure 1).
2. Using a screwdriver, carefully prise open the
detector (Figure 2).
3. Remove the interior part (Figure 3).
4. Fix the base to the wall between 1.8 m and
3.0 m (5.9 to 9.8 ft.) from the floor. For flat-
mounting use a minimum of two screws
(DIN 7998), at least one in position A and one
in position B. For corner-mounting use screws
in positions C or D (see Figures 4 and 5).
Note:
tamper. Non pry-off positions are shown in the
warning box.
5. Wire the detector. See Figures 7 and 8.
Note:
National Electrical Code, NFPA 70 and CSA
C22.1, Canadian Electrical Code, Part I, Safety
Standard for Electrical Installations.
Figure 16 shows a single detector wiring,
Figure 17 — multiple devices connection.
CP
ST400
Not all screw positions have pry-off
All wiring must be provided according to
P/N 149973999-3 (ML) • REV D • ISS 17OCT13