Publicidad
Idiomas disponibles
Idiomas disponibles
|
400B SERIES ELECTRIC DIAPHRAGM PUMPS
Anti-Drip Nozzle Spout Kit 400KTF0237
For use with Norwesco and other nozzles with a 1 3/16" outside diameter.
Installation
1. If there is a raised plastic notch on the nozzle, carefully remove it
with a file before installing the anti-drip spout.
2. Apply soapy water to the end to aid in the installation. Place the
anti-drip spout on the nozzle as shown at right. Tap the spout with a
rubber mallet until it is fully engaged. The space between the end of
the spout and the bend in the nozzle should be slightly more than 1
3/4" when pressed fully into place.
Proper Use
Place the nozzle into the container to be filled BEFORE turning the
pump on.
After pumping, shut off the valve handle then gently shake the nozzle
BEFORE removing it from the container. The spout will open when it
senses pressure greater than 1 psi. Flow restriction will be minimal.
Diaphragm and Check Valve Orientation Detail
Manufacture
Date Information
Ball Only in Bottom Seats
sotera.com
Nozzle
Outlet Valve with Spring, Upper Holes (2)
Ball (4)
Ball Seat - No Cross, Upper Holes
Cross and Spring,
Bottom Holes
OPERATION MANUAL
Anti-Drip Nozzle Spout
1 3/4"
11
Publicidad
