DeWalt DC305 Manual De Instrucciones página 12

OPERATION
WARNING: To reduce the risk of serious personal injury,
depress the trigger lock button and disconnect battery
pack before making any adjustments or removing/installing
attachments or accessories. An accidental start-up can cause
injury.
Installing and Removing the Battery Pack
(Fig. 4)
NOTE: For best results, make sure your battery pack is fully charged.
To install the battery pack (G) into the tool handle, align the base of the
tool with the rails inside the tool's handle and slide the battery pack
fi rmly into the handle until you hear the lock snap into place
To remove the battery pack from the tool, press the release buttons (F)
and fi rmly pull the battery pack out of the tool handle. Insert it into the
charger as described in the charger section of this manual.
FIG. 4
F
Blade Installation and Removal (Fig. 5–7)
Different blade lengths are available. Use the appropriate blade for
the application. The blade should be longer than 3-1/2" (88.9 mm)
and should extend past the shoe and the thickness of the workpiece
during the cut. Do not use jigsaw blades with this tool.
G
WARNING: Cut hazard. Blade breakage may occur if the blade
does not extend past the shoe and the workpiece during the cut
(Fig. 5). Increased risk of personal injury, as well as damage to the
shoe and workpiece may result.
FIG. 5
TO INSTALL BLADE INTO SAW
1. Open blade clamp release lever (C)
up.
2. Insert blade shank from the front.
3. Close blade clamp release lever down.
NOTE: The blade can be installed in
four positions as shown in Figure 7.
TO REMOVE BLADE FROM SAW
CAUTION: Burn hazard. Do not touch
the the blade immediately after use.
Contact with the blade may result in personal injury.
1. Open up blade clamp release lever (C).
2. Remove blade.
10
FIG. 6
C