Publicidad
Idiomas disponibles
Idiomas disponibles
4. Verify that the on/off switch is in the 'O' OFF position before plugging the power cord into the
power outlet. Plug the power cord into the outlet (Fig. 4 & 5).
the power cord from the outlet.
7. After use, empty the collection tank by unscrewing the drain cap. Drain liquids into a suitable
IMPORTANT! When vacuuming large quantities of liquids, do not immerse the nozzle completely
capacity. You will notice an increase in motor speed. When this happens, turn off the machine,
disconnect from power supply, and drain the liquid into a suitable receptacle or drain. To continue
off and remove plug from power supply. Empty the collection tank, clean, and dry the inside and
outside before storage.
REMEMBER!
must be installed before dry vacuuming again.
2
6
This Wet/Dry Vacuum converts to a detachable blower that can be used for leaf blowing in yards,
decks and patios. To use the blower feature, follow the instructions listed below.
WARNING:
IN CANADA, CSAZ94.3) BEFORE USING BLOWER.
CAUTION:
WARNING:
INHALED.
1. Verify that the power cord is disconnected from the outlet (Fig. 1).
2. Remove the noise diffuser from the blower port (Fig. 2).
3. Squeeze the locking lever and lift the detachable blower from the collection tank lid (Fig. 3 & 4).
blower concentrator nozzle (Fig. 5 & 6).
BLOWER OPERATION
3
7
ALWAYS WEAR SAFETY GOGGLES COMPLYING WITH ANSI Z87.1 (OR
KEEP BYSTANDERS CLEAR FROM BLOWING DEBRIS.
WEAR A DUST MASK IF BLOWING CREATES DUST THAT MIGHT BE
4
5
9
8
11
10
Publicidad
