Publicidad
1
5
9
10
8
FAN
UK
WARNING: NEVER PLUG IN THE FAN
WHEN IT IS TAKEN APART, THIS MAY
CAUSE ELECTRICAL HAZARDS. READ
AND SAVE THESE SAFETY INSTRUCTIONS
BEFORE USING THIS FAN.
SAFETY INSTRUCTIONS:
– Use the fan only as described in this manual.
– This product is intended for household use
2 | Instructions for use – Fan
3
6
only.
– Not for commercial, industrial, or outdoor use.
– Do not immerse unit, plug or cord in water or
any other liquids.
– Do not spray the fan with liquids.
– Do not cover the fan.
– Do not use in humid spaces or near a sink.
– Do not use in the presence of explosive and/or
flammable fumes.
– Do not place the article or any part of it near
open fire or another heat source.
– Always place out of reach of children.
– Always place on a stable surface.
– Remove all objects in the direct vicinity of
4
– Never put anything through the ventilation
– Do not place near an open window.
– This appliance is not intended for use by
2
Always unplug from the socket when:
– not in use
– moving the article from one location to
– maintaining or servicing parts
– cleaning the article
Do not use when:
– plug or cord are damaged.
– the fan has fallen.
– the fan is not functioning properly.
7
– the fan is damaged in any way.
– Do not hang or mount the fan on a wall or ceiling.
– Do not operate the fan if the grills are not
– When the cord is damaged it must be replaced
ASSEMBLING OF THE STAND:
11
1. Place the 2 bases crossways on top of each other
2. Remove the adjusting screw, pull the extension tube
3. Place the ventilator on top of the extension tube and
ASSEMBLY INSTRUCTIONS
1. Place the back side of the ventilation grille on the
2. Place the propeller as close as possible to the motor
3. Place the front of the grille on the rear. Check if both grilles
4. Secure the grill by fastening the security bolt and nut
USERS INSTRUCTIONS
Place the ventilator on a solid, flat surface. By turning the
speed button you can select the different speed options
0 - Off
1 - Low speed (light breeze)
2 - Normal speed
3 - High speed
the article in order not to block the swerving
mechanism.
cage and always keep under supervision when
switched on.
persons (including children) with reduced
physical, sensory or mental capabilities, or
lack of experience and knowledge, unless they
have been given supervision or instruction
concerning use of the appliances by a person
responsible for their safety.
another
properly placed.
by a certified electrician.
Place the pointer in top
and screw firmly with the
9
supplied screws (4 pcs). Use a PH1 cross-head
screwdriver (not included).
upwards and make sure it does not slip away. Push the
protection cover
over the pointer downwards, make
10
sure it falls over the two bases, and screw the adjusting
screw again.
adjust it with the clamping nut
.
11
motor spindle
. Make sure the security bolt and nut
1
are at the bottom
. Fasten it with the fixing nut
2
spindle and fasten it with the fixing nut
are properly placed before closing with 2 clamps
.
6
.
8
.
3
.
4
.
5
Publicidad
