Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLING THE WALL CONTROL
REMEMBER to turn off the power before you begin.
NOTE - Secures to any surface or application: flat wall, single gang
box, multi gang box.
Option 1. Flat Surface Installation
Select a desired location. Use the wall plate to mark the
1
location of the mounting holes. Plastic wall anchors or
mounting screws are needed for this application. (Fig. 1)
2
Seat the cradle B into the wall plate. Secure the wall plate to
the wall using the provided hardware.
3
Snap the face plate cover onto the wall bracket.
4
Remote transmitter will be held in place with built in magnets.
Cradle B
Wall plate
Plastic
anchor
Wall
Fig. 1
HIRO Control System
Option 2. For single gang box
Face plate
Transmitter
Remove the existing wall plate and the old switch from the wall outlet
1
box.
2
Seat the cradle A into the wall plate. (Fig. 2)
Connect the black lead wires from the switch in the cradle A to the
3
black wires in the switch box. Hot input wire to one of the cradle A
switch leads. Power lead to the fan is connected to the remaining
switch lead.
4
Connect the wall plate / cradle A assembly to the wall outlet box
using the supplied hardware.
5
Snap the face plate cover onto the wall bracket.
6
Remote transmitter will be held in place with built in magnets.
Outlet box
Wall plate
Fig. 2
©2019 Hinkley Lighting, Inc. | hinkley.com |
Cradle A
Face plate
Transmitter
11
Publicidad
