Tabla de contenido
Publicidad
Introduction of Function Buttons on the Remote Controller
On/off Button: Push this button to start the unit operation. Push the button again to stop the unit
operation.
Mode Button: Each time you press the button, a mode is selected in a sequence that goes from AUTO
COOL DRY HEAT and FAN only as the following figure indicates:
AUTO
COOL
+ Button: Push the button to increase the indoor temperature setting to 30ºC.
- Button: Push the button to decrease the indoor temperature setting to 17ºC.
Fan Button: This button is used for selecting Fan Speed. Each time you press the button, a fan speed is
selected in a sequence that goes from AUTO, LOW, MED to HIGH, then back to Auto. When you select the
AUTO or DRY mode, the fan speed will be automatically controlled and you can not set the fan speed.
SLEEP Button: Press this button to go into the Energy-Saving operation mode. Press it again to cancel.
This function can only be used on COOL, HEAT and AUTO mode and maintain the most comfortable
temperature for you. The unit automatically increases the set temperature by 1ºC per hour (in cooling
mode) or decreases the set temperature by 1ºC per hour (heating mode) during the first 2 hours. The air
conditioner will maintain this temperature (set temperature – or + 2 degrees) during the next 5 hours.
After this period, the air conditioner will shut itself down.
FRESH Button: Long press to active the FRESH function
Swing Button: Press the SWING button to activate the swing feature. Push the button again to stop.
Air direction Button: Press this button to change the swing angle of the louver. The swing angle of the
louver is 6
for each press. When the louver swings at a certain angle which would affect the cooling and
o
heating effect of the air conditioner, it would automatically change the swing direction. No symbol will
appear in the display area when press this button.
Swing Button(left and right): Press the SWING button to activate the swing feature. Push the button
again to stop.
Timer on Button: Press this button to initiate the auto-on time sequence. Each press will increase the
i
auto-timed setting in 30 minutes increments. When the setting time displays 10Hr, each press will increase
the auto-timed setting 60 minutes increments. To cancel the auto-timed program, continue pressing the
button until 0.0 is displayed.
Timer off Button: Press this button to initiate the auto-off time sequence. Each press will increase the
j
auto-timed setting in 30 minutes increments. When the setting time displays 10Hr, each press will increase
the auto-timed setting 60 minutes increments. To cancel the auto-timed program, continue pressing the
button until 0.0 is displayed.
1
3
4
15
2
7
5
8
9
10
SLEEP
6
FRESH
14
12
11
13
DRY
HEAT
FAN
4
91
Publicidad
Capítulos
Tabla de contenido
