When the batteries of the remote controller run out or the remote control-
ler malfunctions, the emergency operation can be done using the emer-
gency buttons.
[Fig.9-1]
DEFROST/STAND BY lamp
Operation lamp
Emergency operation switch (heating)
Emergency operation switch (cooling)
Receiver
C
TEMP.
When resetting "FILTER" display
When the [FILTER] button is pressed 2 times successively after
Note:
ingly.
Caution:
Caution:
E.O.
SW
C
FILTER
ON/OFF
-
-
-
Starting operation
• To operate the cooling mode, press the
seconds.
• To operate the heating mode, press the
seconds.
Stopping operation
• To stop operation, press the
than 2 seconds.
[Fig.9-2]
DEFROST/STAND BY lamp (Orange)
Operation lamp (Green)
Emergency operation switch (cooling/heating)
Receiver
• Each press of the emergency operation switch will toggle the operation
mode.
• Check "COOL/HEAT" with the operation monitor display. (The orange
lamp
follows this monitor display for 5 seconds after pressing the
emergency operation switch.)
[Heat pump type]
Cooling
Heating
Operation Monitor Display
GREEN ORANGE
The orange lamp follows the
STOP
switch operation as indicated
COOL
at the left for 5 seconds, and
then it will return to the normal
HEAT
display.
Turning off
Lighting
:
:
Note:
Operation mode
Set temperature
Fan speed
Horizontal
Caution:
PKA-RP·HAL
Pull both the bottom corners of the intake grille to open the grille, then lift the
button
for more than 2
button
for more than 2
button
or the
button
for more
[Cooling only type]
Stop
Cooling
COOL
HEAT
24°C
24°C
High
High
Downward 4 (5)
Stop
17