Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING
If the battery pack cracks or breaks, with or without
leaks, do not recharge it and do not use. Discard it
and replace with a new battery pack. DO NOT TRY
TO REPAIR IT! To prevent injury and risk of fire,
explosion, or electric shock, and to avoid damage to
the environment:
•
Cover the terminals of the battery with heavy-duty
adhesive tape.
•
DO NOT try to remove or destroy any of the
battery pack components.
•
DO NOT try to open the battery pack.
•
If a leak develops, the released electrolytes are
corrosive and toxic. DO NOT get the solution in the
eyes or on skin, and do not swallow it.
•
DO NOT put these batteries in your regular
household trash.
•
DO NOT incinerate.
•
DO NOT put them where they will become part of
any waste landfill or municipal solid waste stream.
•
Take them to a certified recycling or disposal
center.
9
DESCRIPTION
9.1
PURPOSE
You may use this product for the purposes listed below:
•
Milling wood groove.
•
Cutting wood edge.
WARNING
Always remove the battery pack when attaching,
changing, or adjusting brushless router. Failure to do
so could cause accidental starting, leading to serious
personal injury.
Failure to hold the tool and the battery pack firmly
may cause them to slip off your hands and result in
damage to the tool and battery pack and a personal
injury.
English (Original Instructions)
9.2
OVERVIEW
1
2
3
4
1
Battery pack
3
Dust nozzle
5
Adjusting screw
9.3
TOOL / BATTERY PROTECTION
SYSTEM
The tool is equipped with a tool/battery protection
system. This system automatically cuts off power to
the motor to extend tool and battery life. The tool will
automatically stop during operation if the tool or battery
is placed under one of the following conditions:
OVERLOAD PROTECTION
When the battery is operated in a manner that
causes it to draw an abnormally high current, the
tool automatically stops without any indication. In this
situation, turn the tool off and stop the application that
caused the tool to become overloaded. Then turn the
tool on to restart.
OVERHEAT PROTECTION
When the tool or battery is overheated, the tool stops
automatically and the lamp blinks. In this case, let the
tool and battery cool before turning the tool on again.
OVERDISCHARGE PROTECTION
When the battery capacity is not enough, the tool stops
automatically. In this case, remove the battery from the
tool and charge the battery.
9.4
ELECTRONIC FUNCTION
The tool is equipped with the electronic functions for
easy operation.
7
6
5
2
Router base
4
Straight guide
6
Lock lever
EN
Publicidad
