Publicidad
Idiomas disponibles
Idiomas disponibles
EN
•
Constant speed control
The speed control function provides the constant
rotation speed regardless of load conditions.
•
Soft start
The soft-start function minimizes start-up shock, and
makes the tool start smoothly.
10
INSTALLATION
Always be sure that the tool is switched off and the
battery pack is removed before carrying out any work
on the tool.
10.1 UNPACK THE MACHINE
Make sure that you correctly assemble the machine
before use.
•
If parts of the machine are damaged, do not use
the machine.
•
If parts are missing, do not operate the machine.
•
If parts are damaged or missing, contact the
service center.
1. Open the package.
2. Read the documentation provided in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and packing material in compliance
with local regulations.
For your personal safety, do not insert battery before
the tool is assembled completely.
10.2 INSTALL OR REMOVE BATTERY
PACK
Always switch off the tool before installing or removing
of the battery pack.
Hold the tool and the battery pack firmly when
installing or removing battery cartridge. Failure to hold
the tool and the battery pack firmly may cause them
to slip off your hands and result in damage to the tool
and battery pack and a personal injury.
English (Original Instructions)
CAUTION
WARNING
WARNING
WARNING
CAUTION
CAUTION
1
2
1
Red indicator
3
Battery pack
To remove the battery pack, slide it from the tool while
holding down the button on the front of the pack.
To install the battery pack, align the tongue on the
battery pack with the groove in the housing and slip it
into place. Insert it all the way until it locks in place
with a little click. If you can see the red indicator on the
upper side of the button, it is not locked completely.
Always install the battery pack fully until the red
indicator cannot be seen. If not, the battery may
accidentally fall out of the tool, causing injury to you
or someone around you.
Do not install the battery pack forcibly. If the pack does
not slide in easily, it is not being inserted correctly.
10.3 INSTALL OR REMOVE ROUTER
BIT
Do not tighten the collet nut without inserting the bit.
The collet cone may break.
Insert the router bit all the way into the collet cone.
Press the shaft lock and tighten the collet nut with
the wrench or tighten the collet nut securely with the
two wrenches. To remove the bit, follow the installation
procedure in reverse.
1. Insert the router bit all the way into the collet cone.
8
3
2
Button
CAUTION
CAUTION
NOTICE
Publicidad
