Publicidad
Idiomas disponibles
Idiomas disponibles
EN
SAFETY
ADVICE
• It is of utmost importance to assemble all of the parts according to
the directions. Do not skip any steps.
• Always wear work gloves during panel sliding.
• Some parts may have sharp edges. Please be careful when
handling components.
• Always wear shoes and safety goggles when working with
extruded aluminium.
• If using a step ladder or power tools make sure that you follow the
manufacturer's safety advice.
• Keep children away from the assembly area.
• Do not touch overhead power cables with the aluminium profiles.
• Do not attempt to assemble the product in windy or wet conditions.
• Dispose of all plastic bags. Keep them out of reach of small children.
• Do not climb or stand the roof.
• Do not hang or lay the profiles.
• Do not position your product in an area exposed to excessive winds.
• Do not attempt to assemble this product if you are tired, have taken
drugs or alcohol or if you are prone to dizzy spells.
• Make sure there are no hidden pipes or cables in the wall before
inserting the pegs.
• This product is designed to be used mainly as a Door Awning.
• Heavy snow load on the roof can make it unsafe to stand below
or nearby.
• The wall anchoring kit supplied with this product is suitable for
concrete or solidbrick walls. Other wall types need an accordant
wall fixation kit.
CARE &
MAINTENANCE
• When your product needs to be cleaned, use a soft cloth and rinse with
cold clean water.
• DO NOT use acetone, abrasive cleaners or other special detergents to
clean the panels.
• Clean the product once assembly is complete.
BEFORE &
DURING ASSEMBLY
1. Selecting a site:
- Choose your site carefully before beginning assembly.
- Consider the door's opening - inside or outside.
- The product must be positioned and fixed on a flat level surface.
2. This is a multi-part assembly best achieved by two people.
Allow at least half a day for the assembly process.
3. Take all components & parts out of the packages.
Sort the parts and check against the content parts list.
4. Parts should be laid out close at hand.
Keep all small parts (screws etc.) in a bowl so they do not get lost.
5. Please note multi-sided profiles are used in this product.
As a result some holes in the profiles are not used during assembly.
6. Please review entire instructions before starting.
Carry out the assembly steps in exact order.
7. Please consult your local authorities if any permits are required prior
to constructing the product.
8. During assembly use a soft surface below the parts to avoid
scratches and damages.
9. You are solely responsible for determining whether the handling,
storage, assembly, installation or use of this product is safe and
appropriate in any location or for any given application.
10. The manufacturer is not responsible for any damages or injury to you,
any other person or any property resulting from the improper handling,
storage, installation, assembly or use of this product, or the failure to
follow the manufacturer's written instructions regarding the handling,
storage, installation, assembly and use of this product.
11. This product is intended for normal residential use only. Do not use
this product for any application that is not recommended in these
instructions or building codes in effect in location where this product
will be used. Always take care and use appropriate safety equipment
(including eye protection) when assembling or installing this product.
12. We recommend checking for restrictions or covenants for building
this product in your area. In addition we advise to check if you need
to submit any forms or if any permit is required prior to building
the product.
Publicidad
