Marmitek WHE4 Manual Del Usuario página 8

2 Use
2.1 4K transmitter and receiver
1. Turn ON the second TV or projector and select the correct HDMI input to which
the 4K receiver is connected.
2. Turn ON the HDMI source.
3. Use the switch at the back to turn ON the 4K transmitter and receiver.
4. During system startup (30 sec.) a startup screen will appear on the 4K receiver
and the status LED on both the 4K transmitter and 4K receiver will flash until the
signal connection between the two has been established.
5. When the connection is established and the HDMI source is properly
connected, a video signal will appear on the (second) TV.
6. With proper operation, the LED on the top of the 4K transmitter and receiver will
be solid blue.
7. If no video signal appears, check the lights according to the overview in section
2.3.
Please note: To be able to watch TV locally (via the HDMI output of
the transmitter), the 4K transmitter should always be switched on.
2.2 4K transmitter only
When you do not want to watch video on the second TV or projector,
you can turn off the 4K receiver and keep watching video over your
transmitter. While watching video over your 4K transmitter only, you
can also view your 4K video in HDR.
2.3 Status of the lights
The LED in the top-plate will indicate the status of the 4K transmitter
and receiver:
4K transmitter
Red (blinking)
Blue (blinking)
Blue
Purple
8
Starting up
Waiting for connection
Connected
No supported video signal
© MARMITEK