Publicidad
Idiomas disponibles
Idiomas disponibles
6.1
Screw the Two Threaded Studs (supplied) into the
Tapped Holes in the Hanger Bracket (Figure 29).
NOTE: Be sure the wires stay on the outside of the
threaded rods when installing the ceiling cover.
6.2
Lift the Ceiling Cover up to the Threaded Studs and
turn until Studs protrude through the Holes in the
Ceiling Cover (Figure 30).
Secure the Ceiling Cover in place by sliding
Lockwashers (supplied) over the Threaded Studs
and installing the Two Knurled Knobs (supplied)
(Figure 30).
Tighten the Knurled Knobs securely until the Ceiling
Cover fits snugly against the ceiling and the Hole in the
Ceiling Cover is clear of the Downrod.
WARNING
!
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the outlet box and
not pinched between the ceiling cover and the ceiling.
6.3
Place the Shade into the opening of the Lower Housing
Assembly. Align the Three Flat Areas on the top edge of
the Shade with the Three Raised Dimples on the Lower
Housing Assembly and turn the Shade Clockwise until it
stops (Figure 31).
NOTE: Periodically check that the Shade is seated
fully clockwise in the Lower Housing Assembly.
You have now completed the assembly of your new
Ceiling Fan.
P l e a s e
c a l l
t h e
1 - 8 0 0 - 6 5 4 - 3 5 4 5 i f y o u h a v e a n y q u e s t i o n s
about installation and operation of this Ceiling Fan.
6. Final Assembly
T e c h n i c a l
S u p p o r t
Figure 29
1-1/4"
THREADED
STUDS (2)
#8 EXTERNAL
TOOTH
LOCKWASHERS (2)
Figure 30
ROTATE SHADE
CLOCKWISE
SHADE FLAT
AREAS (3)
a t
Figure 31
18
HANGER BRACKET
THREADED STUDS (2)
CEILING
COVER
#8-32 KNURLED
KNOBS (2)
LOWER HOUSING
ASSEMBLY DIMPLES (3)
ETL Model No.: CF840
Publicidad
