Descargar Imprimir esta página

Cloer 6789 Instruction Manual página 9

Ocultar thumbs Ver también para 6789:

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 24
Technical Data
type
volt
678
220-240
Before the first use
Read these operating instructions
carefully before using the appliance
for the first time.
• Remove all packaging parts and, if applicable, sti-
ckers, not the identification plate.
• Before using the first time, clean the grilling surface
by means of a soft cloth.
Safety instructions for operation
The appliance meets the requirements
of the applicable EC directives.
ATTENTION! Always unplug
the appliance when not in use
and before cleaning.
ATTENTION! Grilling surface, power
cover as well as lid get extremely hot
in operation. There is the danger of
burns and fire! Only touch the lid at
the heat-isolated handles.
• Never cover the grilling surface with aluminium foil.
• Do not put saucepans or pans on it, as the heat de-
velopment can cause deterioration of the non-stick
coating.
• Never put baking paper and inflammable mate-
rials on the grilling surface. The immense heat can
cause fire!
• Never let the grill unattended while in operation.
• Keep it well away from swimming/paddling pools,
sprinklers, and hoses.
• Do not place the grill next to inflammable objects.
• Route the cable so it doesn't overhang, and can't be
tripped over or caught.
• Use oven gloves if necessary.
• Never use the grill without the drip tray.
• ATTENTION! Even at the lowest setting of the ther-
mostat (level 1 or lower) the appliance is already in
operation. Unplug the power plug to switch off the
appliance completely.
• During the very first heating up the appliance can
cause slight smoke. After some minutes, however,
smoking will stop again.
• ATTENTION! Do not use charcoal or similar combusti-
bles as well as so-called grill lighters for the
Setup
Plug the base together at the start. For this, take the 5
feet and insert them into the central element:
hz
watt
50/60
2000-2400
Place the connection plate on the central element of
the base. (See figure) Fasten this with the supplied
screws. Put the base aside and continue with the
steel tube.
Screw the threaded pin into the lower tube. Then
take the spacer and place it between the lower and
the upper tube and screw the two tubes together.
Now pick up the base and push the assembled tube
into the base. (see figure) Now fasten the screw to
the position where you want to attach the tray (Posi-
tion A or B). Then insert the tray onto the tube.
In the next step, the lower grill housing can now be
placed on the tube. Now push the grease collection
drawer into the housing from behind.
EN
A
B
9

Publicidad

loading