Stealth Products UniLink Manual De Usuario página 10

Installation
Full-Surface Contact Mount Installation
1. Place the conical socket of the 17mm Ball Link (A) onto the conical mount of
the 1.5" Link (B).
2. Place the 1.5" Coupler (C) onto the 1.5" Link (B) as shown below and secure it
with an M5 Flat Washer and M5 x 0.8 x 25mm Socket Head Screw.
Full-Surface Contact Mount Adjustment
5
A
B
A
C
1. Loosen the M6 x 1.0 x
12mm Button Head
Screws (A) with a 4mm
Hex Wrench.
2. Rotate and/or adjust
the angle of the pad to
the desired position.
3. Tighten the screws
evenly.
EN