Publicidad
Idiomas disponibles
Idiomas disponibles
Operating the unit
I. Assembly before use
1. Battery loading:
Please open the battery box with a screwdriver to load AAA battery. Make sure
that the AAA + pole is placed towards "ON/OFF switch / intensity level volume" as
shown in picture I.
2. Close the battery cover and fix it with the screw.
II. Stick the electrode pads
1. Firstly, open the vacuum pack and take out the self-adhesive electrode pads, and
then detach the plastic films from the gap side with the words "SELF-ADHESIVE ELEC-
TRODE PADS" (as shown in picture II & III).
18
EN
V
IV
I
II
III
Operating the unit
2. Stick the electrode pads on the backside of the device onto the black conductive
rubbers (as shown in picture IV).
VI
3. After the electronic pads are on place, press the surface of unprinted plastic film
with your fingers stronly and move in a circular motion to ensure better adhesion,
and then wait for a few minutes after electrode pads itself completely tightly close
with black conductive rubbers (as shown in picture V).
Finally, please slowly take away the plastic film before use .
III. Adjust the wrist-belt
1. After you have attached the electrode pads, you can wear the the Kyutec Snore
Stopper.
2. Now, please hook the belt into the other "wing" of the device and make sure the
VII
hook is complete locked(as shown in picture VI). Place the Kyutec Snore Stopper 3
cm above the wrist (as shown in picture VII). Finally, tighten it and fix this end of the
belt (as shown in picture VIII ).
Note: Do not pull the belt too tight; otherwise it will lead to poor blood circulation. The
device will function well, when it touches the skin gently.
VIII
19
EN
Publicidad
