Trotec IRD 1200 Manual De Instrucciones página 139

Switching the device on
Once you have completely installed the device as described in
the chapter Assembly and start-up, you can switch it on.
1. Set the on/off switch (2) on the device to I.
ð The operating light (19) flashes.
ð The device is now in standby mode.
2. Press the Power button (23) on the remote control.
ð The segment display (21) indicates P0.
ð The operating light (19) is illuminated.
ð The device is switched on, but does not heat yet.
3. Press the corresponding button (24, 26, 27) on the remote
control to set the desired heating level.
ð The device heats.
ð The selected heating level flashes in the segment
display (21).
ð The operating light (19) is permanently illuminated
during operation.
Setting the timer
The timer allows you to program an automatic switch-off time in
increments of 1 hour up to 24 hours at any heating level.
You can change the heating level during timer programming.
The timer programming remains activated.
ü The device is switched on.
ü The heating level is set.
1. Press the TIMER button (25) several times to set the
desired number of hours until automatic switch-off.
ð The timer LED (20) is illuminated.
ð The segment display (21) indicates the number of hours
until automatic switch-off.
ð The timer has been programmed and the device will
switch off after the predefined time.
2. In order to delete the setting, select 00 hours using the
TIMER button (25).
ð The segment display (21) indicates the number of hours
00.
ð The timer has been deleted.
12
Shutdown
• Switch off the device by pressing the Power button (23) on
the remote control. The operating light flashes. Then set
the on/off switch (2) on the device to 0.
• Allow the device to cool down completely.
• Hold onto the mains plug while pulling the power cable out
of the mains socket.
• Clean the device according to the Maintenance chapter.
• Store the device according to the Transport and storage
chapter.
Errors and faults
The device has been checked for proper functioning several
times during production. If malfunctions occur nonetheless,
check the device according to the following list.
Noise generation (clicking) during switch-on or cooling:
• This is not a fault. The device's metal parts expand when
heated and contract when cooling, and thus generate
noise. This is a perfectly normal process. No measures are
required.
The device does not start:
• Check the power connection.
• Check the power cable and mains plug for damages. If you
notice damages, do not try to take the device back into
operation. Order a new power cable with mains plug from
Trotec and replace the defective power cable with mains
plug with the new one.
• Check the on-site fusing.
• Wait for 10 minutes before restarting the device. If the
device is not starting, have the electrics checked by a
specialist company or by Trotec.
infrared radiant heater IRD 1200 / IRD 1800 / IRD 2400 / IRD 3200
Warning of electrical voltage
Do not touch the mains plug with wet or damp hands.
Info
If you switch off the device via the remote control, the
device will be set to standby mode. If standby
operation is not required, you can switch the device off
via the on/off switch (2).
Warning of electrical voltage
Tasks which require the device to be opened must
only be carried out by authorised specialist
companies or by Trotec.
EN