Publicidad
Idiomas disponibles
Idiomas disponibles
Before use
Before operating your new appliance, please read the following instructions carefully as they contain
important information on safety, installation, operation and maintenance. Keep the instructions for future
reference. On receipt, check to ensure that the appliance has not been damaged during transport.
Transport damage should be reported to the local distributor before the appliance is put to use.
Remove the transport protector before the appliance is put to use. ( fig 1) Hang it on one of the shelves
as it can be used to adjust the door. If the appliance has to be moved, use the protector Remove the
packaging. Clean the inside of the cabinet using warm water with a mild detergent. Rinse with clean
water and dry thoroughly (see cleaning instructions). Use a soft cloth. If during transport the appliance
has been laid down, or if it has been stored in cold surroundings (colder than +5°C), it must be allowed to
stabilise in an upright position for at least an hour before being switched on.
Note: If the appliance is to be laid down, the door must face upwards and the appliance
must be enclosed in the original packaging .
Placement.
For safety and operational reasons, the appliance must not be
installed outdoors. The appliance should be placed on a level surface
in a dry, well ventilated room (max. 75% relative air humidity).
Never place the appliance close to sources of heat such as cookers
or radiators, and avoid placing it in direct sunlight.
Ambient temperature.
The climate class is stated on the nameplate. This specifies the optimum ambient temperature.
Installation
The surface on which the appliance is to be placed must be level. Do not use a frame or similar.
The appliance can be installed as a free-standing unit against a wall, built into a kitchen element, or lined
up with other appliances (fig 4)
Levelling the appliance
It is important that the appliance be absolutely level.
It can be levelled in the following way (fig 2):
1. Level the appliance sideways by screwing the
adjustable feet up or down using the
accompanying spanner.
2. Check that the appliance is absolutely level.
If the appliance is to be placed on a soft surface, e.g. floorboards or a carpet, it is best to recheck
whether the appliance is still level after a period of time as the underlying surface may give under the
weight of the appliance.
Ventilation
Keep ventilation openings, in the appliance enclosure or in the
built-in structure, clear of obstruction. The figures below illustrate the
clearance necessary to achieve the required air circulation.
(Minimum 150 mm above) fig 3
FIG.3
Operator's guide
Climate
Class
SN
N
ST
T
FIG.4
7
Optimum room temperature
da +10 °C a +32 °C
da +16 °C a +32 °C
da +18 °C a +38 °C
da +18 °C a +43 °C
FIG.2
I
UK
D
E
F
NL
P
S
DK
FIN
B
GR
CZ
EE
LV
LT
H
M
PL
SK
SLO
Publicidad
