Publicidad
Idiomas disponibles
Idiomas disponibles
Side by side (Fig.4)
In side-by-side arrangement, there must be at least 25 mm between and at the sides of the cabinets, so
the doors can be opened freely
I
I
Installation of ventilation guard
Close the two ventilation guards placed on the rear of the
appliance, to ensure sufficient air circulation
UK
UK
D
D
E
E
F
F
NL
NL
P
P
S
S
DK
DK
FIN
FIN
B
B
GR
GR
ELECTRONIC CONTROLS
USE THE CONTROL UNIT MANUAL (FLEX) THAT YOU FIND INSIDE THE SHOWCASE.
CZ
CZ
Automatic defrosting.
The appliance is defrosted automatically. Defrost water runs through a pipe and is collected in a tray
EE
EE
above the compressor where the heat generated by the compressor causes it to evaporate.
LV
LV
Cleaning.
Switch off the appliance by pressing the on/ off button before cleaning it inside.
LT
LT
The cabinet is best cleaned using warm water (max. 65°C) with a little mild detergent. Never use
cleaning agents that scour. Use a soft cloth. Rinse with clean water and dry thoroughly. It is important to
H
H
prevent water from entering the control panel.
The defrost water channel, in which condensation from the evaporator runs, is located on the rear wall of
M
M
the cabinet and must be kept clean. Add a few drops of disinfectant, e.g. Rodalon, to the defrost water
drain a couple of times a year, and clean the drain using a pipe cleaner or similar. Never use sharp or
pointed implements. The sealing strip around the door must be cleaned regularly to prevent
PL
PL
discolouration and prolong service life. Use clean water. After cleaning the sealing strip, check that it
continues to provide a tight seal. Dust collecting on the compressor and in the compressor compartment
SK
SK
is best removed using a vacuum cleaner.
SLO
SLO
Operator's guide
8
!
Publicidad
