Publicidad
Idiomas disponibles
Idiomas disponibles
WARNINGS
SOURCE OF WATER AND PRESSURE
1. The quality of the incoming water must be that of tap water, complying with
current legislation.
2. To ensure the quality of the effluent water, do not install the product in a water
supply pipe with a water pressure higher than 0.4 MPa. If the water pressure
exceeds 0.4 MPa, a pressure reducing valve must be installed (not included,
should be purchased separately).
TEMPERATURE CONTROL
1. The inlet water temperature of this product should be between 5-38º. Do not
install the product in a place where the temperature is too high or too low to
avoid damaging the product.
2. This product cannot filter hot water.
DAILY MAINTENANCE
Should the product breakdown, shut off the water inlet and power supply
promptly and contact your local distributor or customer service.
1. Do not install this product in locations prone to falls or exposed to harmful chemicals.
2. Do not turn the product upside down when installing.
3. This product is intended for domestic use only.
4. This product must be repaired by professionals designated by the brand.
STORAGE
Avoid using and storing the product on the following occasions:
• Places exposed to direct intense sunlight can easily cause discolouration and
ageing of equipment parts.
• Below 5°C and above 38°C, it is easy to damage the equipment.
• Do not place heavy objects on the product.
REPLACEMENT OF PARTS AND FILTER ELEMENTS
1. The maintenance of this product, the replacement of the filter and components,
requires the use of spare parts approved by our company. Problems caused
by the use of unauthorised parts or accessories are not covered by the warranty.
2. The maintenance of this product, the replacement of the filter and components.
are services paid for by the customer.
OTHER PRECAUTIONS
Do not allow the product to come into contact with or near sources of heat / open
flame and other flammable/easily volatilised substances.
19
EN
Publicidad
