Publicidad
Idiomas disponibles
Idiomas disponibles
LOAD THE MACHINE
ES
▶Make sure the trimmer is turned off..
1. Connect the cable to the machine.
2. And plug it into the domestic outlet.
PT
▶Check if the light point lights up,
indicating the charging status.
▶Charging is complete after approx. 1 hour.
EN
▶Once the charging light turns off, it means
that it is fully charged.
▶The recommended ambient temperature
for charging is 0ºC-35ºC. Battery performance may decrease at
FR
extremely low temperatures and the battery may not charge properly.
▶A full charge supplies power to run for about 45 minutes.
▶When charging the trimmer for the first time or when it has not been
in use for more than 6 months, the light spot on the main body may
not illuminate for a few minutes. Please charge it for more than 8
hours in such a case.
▶To ensure a long life of the product, you can start shaving once the
battery is fully charged. Likewise, it will not load it again until it has
been fully downloaded.
▶Please do not carry the shaver inside the closed bag.
▶If the power cord is damaged, do not use the machine.
USING THE TRIMMER
▶Make sure the trimmer is turned off.
▶Mount the desired comb attachment and adjust the cutting height
as necessary. It can also be used without the comb attachment.
(Cutting height: about 0.5mm)
• The actual length of the hair will be a little longer than the height
you set.
▶Press the switch to turn it on.
USING THE COMBINATION ACCESSORY
▶Be careful not to cut your hand on the blade when attaching or
removing the comb attachment.
▶Always make sure the trimmer is turned off.
1. Mount the comb attachment to the main body until it
clicks.
▶Cutting height (estimate)
• 1mm to 10mm comb - for beards
• 11mm to 20mm comb - for hair
▶The trimming height of the body hair comb attachment cannot be
Instruction manual
▶This comb attachment is trimmed to a length of approximately
2. Turn the dial and adjust the cutting height indicator mark
to the desired height.
BEARD TRIM
▶Do not use with shaving foam applied or when beard is wet. A wet
BEARD LENGTH ADJUSTMENT
▶Make sure the trimmer is turned off.
▶1. Attach the beard comb attachment to the main body.
▶2. Set the trim height.
▶3. Holding the trimmer with the power switch facing up, trim by
▶Hair clippings can accumulate inside the attachment when trimming
adjusted.
1.5mm
beard can stick to the skin or clump together, making it difficult to
cut.
bringing the blade in contact with the skin and moving the trimmer
against the flow of the beard.
a large volume of beard, so dispose of
after each use.
ref. 07629
Publicidad
