Publicidad
Idiomas disponibles
Idiomas disponibles
TRIMMING WITHOUT THE COMB ATTACHMENT / TRIMMING
SOFT HAIR
▶1. Remove the comb attachment.
▶2. Holding the trimmer with the power switch facing out, cut with the
blade in contact with the skin.
▶The trimmer cannot trim hair to lengths less than 0.5mm
BEARD DESIGN
▶Use the trimmer without any comb attachment to properly shape
your beard.
▶Use the precision trimmer to trim tight areas and to trim off the rails.
ABOVE AND BELOW THE LIPS
▶Holding the trimmer with the power switch on the bottom, cross-cut
a line with the blade at a 90° angle to the skin.
▶Holding the trimmer with the power switch facing the skin, cut with
the blade in contact with the skin.
TRIM TO A UNIFORM LENGTH
▶Attach the hair comb accessory to the
main body.
▶Set the trim height.
▶Holding the trimmer with the power
switch.
▶The cut by moving the trimmer slowly
against the flow of hair.
▶Cut slowly when crisscrossing from
various directions to avoid missing
stitches.
TRIM BODY HAIR
▶Trim underarms and bikini lines with the body hair comb attachment.
▶The cutting height is approximately 1.5 mm.
▶Do not use when body hair is wet. Wet body hair can stick to the skin
Instruction manual
▶1. Attach the body hair comb attachment to
▶2. Holding the trimmer with the power
▶The desired results may not be achieved if
CLEANING
▶Turn off and unplug the appliance to start cleaning.
▶The performance and durability of the machine will depend on
CLEANING FOR THE SHAVING UNIT
CLEANING THE SHAVING HEADS
or clump together, making trimming difficult.
the main body.
switch. Cut by bringing the blade in contact
with the skin and slowly moving the trimmer
in the direction shown.
the hair is too long. In this case, trim the
hair to a length of about 10mm before using
the trimmer.
regular cleaning.
• You should clean the shaving unit every week.
• You need to run a brush over the top first.
• Afterwards, press the power button, it will help to remove the hair
from the heads.
• Run the brush inside and under the heads.
• Once everything is clean, close the heads again.
• The cleaning of the heads should be every two months.
• Press the release button and remove the heads.
• Slide the shaving heads out of the retaining frame one at a time.
(Note: Do not change the blade group and guards, or else it will
affect the performance of the appliance)
ref. 07629
ES
PT
EN
FR
Publicidad
