universalblue UVT1316-21 Manual De Instrucciones página 30

ENGLISH
side (fig. 4).
• Step 05: Assemble the rod with the fan
head (fig. 5)
• Step 06: Adjust the fastening screw
through the rod and the top of the fan
head. (fig. 6).
• Step 07: Lock the screw position with
the fork. (fig. 7).
• Step 08: Place the fixing stick at the top
end of the rod (fig. 8).
• Step 09: Set the rod position by screwing
it in (fig, 9).
• Step 10: Slide the rod down as shown in
the picture (fig. 10)
• Step 11: Disassemble the cable holder to
split them. (fig.11 and 12).
• Step 12: Using a drill, make the holes in
the ceiling according to the dimensions
of the fan screw holes (fig. 13).
• Step 13: Note the diffrents installation
between a wooden and a concrete
ceiling (fig. 14).
• Step 14: Disconnect general electricity
current (fig. 15).
• Step 15: Connect
their respective positions (fig. 16)
(phase:brown, neutral: blue, ground:
green)
• Step 16: Attach the rod to the ceiling
support and turn it until you hear a
"click" sound (fig. 17 and 18).
• Step 17: Add the remote control receiver
to the base of the ceiling (fig. 19).
• Step 18: Connect the fan cables through
the remote control receiver, and connect
it to the base too (fig. 20).
• Step 19: Attach the cover to the fan
base by turning it and pressing it down
slightly (fig. 21)
• Step 20: Add the LED lamp to the fan
head (fig. 22) and after that the cover
(fig. 23).
• Step 21: After completing all the
previous steps, turn on the electricity
current again and start your new fan
(fig.24).
Note: You can also mount the blades in
the fan body before making the electrical
connections.
30
the wiring in
Once you have finished the installation
make sure the product works correctly. Pay
special attention to any strange oscillation
or malfunction in any of the fan parts.
In case the product shows any imbalance
or vibration, you can use the balancing kit
included to adjust it.
Remote control connection:
See picture 04 on page 5.
L : AC IN 220-240V
N : AC IN 220-240V
Blade balance kit:
Included in the purchased product you will
find a kit supplied to prevent the blades
from moving unbalanced.
The fan may wobble during functioning
due to an irregularity in th eblades or
blade support. Also, improper installation
or an inlcined angle can cause additional
problems.
It is recommended to follow the next
procedure to solve any of these problems :
• Make sure that all blades are screwed
firmly into their mounts and are tight to
the fan body.
• Looking at the fan from below, check
and make sure that no blade holder is
bent so all the blades are in the correct
position.
• Using a ruler you can check the blade
route. Simply place the ruler against the
roof vertically, and note the distance
from the edge of the blade to the roof.
Carefully spin the blades with your
hand to check all the blades. If the
blades are not aligned, the holder can
be slightly bent up or down to align it
with the rest of the blades.
If after following all these steps the problem
is not solved, a small adjustment must be
made using the balance kid provided.
• Turn the fan on and change the speed
until the most noticeable swing occurs
(usually the highest speed).