Publicidad
Idiomas disponibles
Idiomas disponibles
• Turn off the fan. Select a blade and
place the balancing clip on the edge of
it, between the holder and the tip.
• Turn the fan back on and see if the tilt
has improved or worsened. Turn the fan
off and change the clip to another blade
to check again. Repeat this process for
all blades and note which blade has the
most noticeable improvement.
• Put the clip back on the blade where
you noticed the greatest improvement.
Move the clip along the blade and turn
on the fan to find the position where the
clip offers the better improvement.
• Next, remove the clip and place one of
the balance weights on the point where
the clip was placed. To do so separate
the white sticker with your fingernails
or, if necessary, carefully use a knife or
scissors.
• Make sure the problem has been solved.
If the imbalance persists, repeat the
process. You can use light weights on
those blades that may need it.
USING THE APPLIANCE
This device is very easy to use and does
not require much knowledge. However, we
advise you to familiarize yourself with the
instructions below.
The fan has 6 power levels that can be
selected through the remote control. It also
has a timer of up to 8 hours.
Remote control:
See picture 07 on page 8.
The device incorporates a remote control,
for a more comfortable and efficient use.
In order for the remote control to work, it
must always be aimed at the fan.
Before you start using it, please take a few
minutes to familiarize yourself with the
functions:
10.
Fan ON/OFF button: Press it to
turn the device on or off.
11. Light ON button: Press it to turn on the
lights of the device. Press it as many
times as necessary to select among
the different colours of light, with a
choice of three options.
12. Light OFF button : Press it to turn off
the lights of the device.
13. Automatic
when the fan is on, press the button
to automate the fan according to the
temperature of the room. When this
function is activated:
• If the temperature of the room is
24ºC or lower, the fan will activate
speed 1.
• If the temperature of the room
is between 24-28ºC, the fan will
activate speed 3.
• If the temperature of the room is
28ºC or higher, the fan will activate
speed 6.
• To desactivate this mode, press the
automatic temperature button again.
14.
Buttons 1 to 5: Press these buttons
to set the fan speed, with 1 being the
lowest and 5 the highest.
15. Natural wind mode button: press it to
activate the natural wind mode
16. Winter/summer
: Press the button to activate the
winter function or to return to the fan
function (summer mode).
17. Timer button:
• 1H: Setting for the fan to turn off
automatically after one hour of
operation.
• 4H: Setting for the fan to turn off
automatically after four hours of
operation.
• 8H: Setting for the fan to turn off
automatically after three hours of
operation.
In order to be able to use the ceiling fan
through the remote control, the receptor
included with this device must be installed
before, as explained in the installation
section of this manual.
To use the remote control, you must add 2
batteries to the bottom of the remote.
If your model has LED light with different
colour tones, you can change the colour
temperature
button:
function
button
EN
31
Publicidad
