Maintenance And Cleaning - WIKA P-3x Manual De Instrucciones

6. Commissioning, operation/7. Maintenance and cleaning
6.6 Commissioning of CANopen instruments
Connect the CAN interface (e.g. PEAK PCAN-USB) to the PC and the pressure sensor.
■
Start the CAN software (e.g. PEAK PCAN-View).
■
Make sure that the correct bit rate and node ID of the pressure sensor is used.
■
For further information see "Quick Start Guide" under "Additional Instructions".

7. Maintenance and cleaning

7.1 Maintenance
This instrument is maintenance-free.
Repairs must only be carried out by the manufacturer.
7.2 Cleaning
CAUTION!
Before cleaning, correctly disconnect the instrument from the pressure supply, switch it
■
off and disconnect it from the mains.
Clean the instrument with a moist cloth.
■
Residual media in dismounted instruments can result in a risk to persons, the
■
environment and equipment. Take sufficient precautionary measures.
Do not use any pointed or hard objects for cleaning, since the diaphragm of the process
■
connection must not be damaged.
For information on returning the instrument see chapter 9.2 "Return".
WIKA operating instructions pressure transmitter, model P-3x
EN
21