Publicidad
Idiomas disponibles
Idiomas disponibles
• The dust collector can be extended by pulling
the dust collector extension (9) until it locks into
position.
• The extension can be retracted by pressing the
button (10) and pushing the extension back into
the dust collector.
• The dust collector should be returned to the
storage position under the appliance after use and
while charging the appliance.
Use
• Before first use, the battery must be charged for
at least 9 hours.
• Plug the appliance into the charger whenever
power gets low.
Charging the battery (fig. D)
• Make sure that the appliance is switched off. The
battery will not be charged with the on/off switch
(4) in the on position.
• Place the appliance on the charging base (7) as
shown. The charging indicator will be lit.
• Plug in charger and leave the appliance on
charge for at least 9 hours. While charging, the
charger may become warm. This is normal and
does not indicate a problem. It is safe to leave the
appliance connected to the charger indefinitely.
The charger automatically reduces power
consumption when charging is complete.
• When charging is complete, the LED will turn off.
• After a period of time the charger will then enter
a low-power mode, indicated by a slow blinking
LED.
• Once the unit is removed from the charger,
operated and placed back on the charger, the
cycle will start again from the beginning.
WARNING:
battery at ambient temperatures below 39°F (4°C)
or above 104°F (40°C).
Optimizing the suction force
Rotating the bowl (fig. A) agitates the filter to remove dirt; however, in order to keep the
suction force optimized, the dust container and filters must be cleaned regularly.
Cleaning the dust container and filters (fig. F - J)
There are two methods of cleaning the bowl, a quick empty method and a thorough
clean method.
For the quick empty method use the following instructions.
• Press the release latch (6) and open the container door (5) (fig. F).
• Empty the dust container (11).
Do not charge the
Switching on and off (fig. E)
• To switch the appliance on, slide the on/
off switch (4) forward to position I.
• To switch the appliance off, slide the on/
off switch (4) back to position 0.
5
D
E
F
n
Publicidad
