Publicidad
Idiomas disponibles
Idiomas disponibles
MC-400
STEP 6.
Attach the upper and lower (with tube padding) accessory bar rails to the tabs (A) on the handle columns using 4
M8x40 screws (13) and nuts (5). Tighten the screws (rotate right) using the Allen key.
13
11
5
A
10
12
STEP 7.
Slide the tube joint covers toward the handle columns so that the joint is
fully covered.
STEP 8.
11
Bring the accessory bar (14) into position, with the dumbell hooks facing
upward, behind the centres of the accessory bar rails.
STEP 9.
Attach the accessory bar to the upper and lower accessory bar rails using
14
2 M8x55 screws (15) and nuts (5). Tighten the screws (rotate right) using
the Allen key.
STEP 10.
Slide the 2 remaining pieces of tube padding (11) over the horizontal
5
15
accessory bar tubes.
The machine should resemble the image below and is ready for use.
After the installation of this treadmill it is possible to see the two connecting lines of the two ends of the running
surface, which guarantees its stability. And it is carried out by means of a meticulous heat-sealing process during its
manufacture. It is the longest lasting way to join the tape itself and ensure the life of the product.
EN
57
Publicidad
