Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly - Hanging the Fan (continued)
5
Wiring the fan to the receiver
NOTE: The fan comes with 8 in. lead wires for use with the
provided 6 in. ball/downrod assembly (B). If you wish to use
a longer downrod, attach the 42 in. extension wire (K) to
the fan by connecting the molded adaptor plugs from the
extension wires to the adaptor plug from the fan.
□
If using the 6 in. ball/downrod assembly (B) provided, wire the
receiver to the fan wires by connecting the molded adaptor
plug from the receiver (I) with the molded adaptor of the fan
motor assembly (E) together.
□
If you wish to use longer downrod, you can use the extension
lead wire (42 in.) (K) provided by connecting the molded
adaptor together.
6
Mounting the fan motor assembly
(standard mount)
WARNING: When using the standard ball/downrod
mounting, the tab in the ring at the bottom of the
mounting bracket must rest in the groove of the
hanger ball. Failure to properly seat the tab in the
groove could cause damage to the wiring.
NOTE: The magnet is pre-attached on the canopy bottom
cover for you to remove and install easily.
□
Align the locking slots of the canopy (C) with the two
canopy screws (SS) and alignment post (QQ) in the slide-on
mounting bracket (A).
□
Push up the canopy (C) and turn it clockwise until the
alignment post (QQ) engages to the round hole and the
canopy screws (SS) engage to the key slots.
□
Firmly tighten the two canopy screws (SS).
□
Align the oval shape on the canopy (C) with canopy bottom
cover (JJ).
□
Push up the canopy bottom cover (JJ) until the canopy screw
(SS) heads engage to the slots on the canopy bottom cover
(JJ) so that the magnetic canopy bottom cover (JJ) can be
attached to the bottom of the canopy (C) properly.
Outlet box
K
QQ
10
Green
A
SS
C
B
JJ
E
Publicidad
