Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly - Standard Ceiling Mount
1
Preparing for mounting
□
Remove the magnetic canopy bottom cover (JJ) from the
canopy (C) by pulling it off.
□
Loosen the two canopy screws (SS) located in the bottom of
the slide-on mounting bracket (A).
□
Turn the slide-on mounting bracket (A) counterclockwise
and lift it up to remove the slide-on mounting bracket (A)
from the canopy (C).
2
Routing the wires
NOTE: The fan comes with 8 in. lead wires for use with
the provided 6 in. ball/downrod assembly (B). If you wish
to use a longer downrod, attach the extension wire (K) to
the fan by connecting the molded adaptor plugs from the
extension wires to the adaptor plugs from the fan.
□
Route the wires exiting the top of the fan motor assembly (E)
through the decorative motor collar cover (D) and then the center
of the canopy bottom cover (JJ).
□
Make sure the opening of canopy (C) is on top and insert the ball/
downrod assembly (B) through the canopy (C).
□
Route the wires exiting the top of the fan motor assembly (E)
through the downrod as shown.
3
Assembling the fan
CAUTION: To ensure wobble-free operation and to avoid
damage to the fan, the downrod (B) and the set screw (KK)
must be completely tightened.
WARNING: Failure to properly install the locking
pin (DD) could result in the fan becoming loose and
possibly falling.
□
Loosen, but do not remove, the set screw (KK) on the collar (PP) on
top of the fan motor assembly (E).
□
Install the ball/downrod assembly (B) by inserting it into the motor
collar (PP), and turning it clockwise until the holes at the bottom of
the ball/downrod assembly (B) align with the holes in the collar on
top of the fan motor assembly (E).
□
Carefully insert the hanger pin (CC) through the holes in the collar
(PP) and ball/downrod assembly (B). Be careful not to jam the hanger
pin (CC) against the wiring inside the ball/downrod assembly (B).
□
Insert the locking pin (DD) through the hole near the end of the
hanger pin (CC) until it snaps into its locked position.
□
Re-tighten the set screw (KK) on the collar (PP) on top of the fan
motor assembly (E).
KK
CC
7
Please contact 1-855-HD-HAMPTON for further assistance.
A
SS
C
JJ
C
JJ
D
B
E
C
JJ
D
DD
B
PP
E
HAMPTONBAY.COM
Publicidad
