Publicidad
Idiomas disponibles
Idiomas disponibles
Electrical safety
When using electric machines always observe the
safety regulations applicable in your country to
reduce the risk of fire, electric shock and personal
injury. Read the following safety instructions and
also the enclosed safety instructions.
Always check that the power supply
corresponds to the voltage on the rating
plate.
Your machine is double insulated,
therefore no earthwire is required.
Replacing cables or plugs
If the mains cable becomes damaged, it must be
replaced with a special mains cable available from
the manufacturer or the manufacturer's customer
service. Dispose of old cables or plugs immediately
after replacing them with new ones. It is dangerous
to connect the plug of a loose cable to a socket.
Using extension cables
Only use an approved extension cable suitable
for the power input of the machine. The minimum
conductor size is 1.5 mm
reel always unwind the reel completely.
3. ASSEMBLY OF ACCESSORIES
Before assembly always remove the plug
from the mains.
Warning! Change accessories by
inserting an accessory into the collet (or
chuck) as far possible to minimize run
out and unbalance.
Assembly of accessories
Fig. 1
Press down the axle locking button (2) and hold
it down. Using the chuck spanner you can undo
the chuck (1). Put the accessory in its place. Hold
down the axle locking button when you fasten the
spring chuck with the spring chuck spanner.
To mount an accessory in the flexible shaft, lock
the spindle by putting the pin in the hole. Then
loosen the chuck with the spanner and place
. When using a cable
2
the accessory. Keep the pin in place and tighten
the chuck. Make sure to remove the pin before
operating the machine.
Operation
Switch on the machine by engaging the on/off
switch (A) By adjusting the adjusting wheel (B)
you can regulate the speed of the Combitool. Do
not put the machine down when the motor is still
running. Do not place the machine on a dusty
surface. Dust particles may enter the mechanism.
Too high a load at a low speed of the
Combitool can burn out the engine.
4. MOUNTING THE FLEXIBLE
SHAFTAND STAND
Flexible shaft
Fig. 2
Screw the ring off the chuck and remove it.
Mount the flexible shaft on the Combitool, placing
the inner shaft (1) in the chuck. The ring of the
flexible shaft (2) can then be fastened onto the
Combitool.
Never operate the axle locking button if
the engine is still rotating.
Stand for the Combitool
• Mount the stand on the side of a workbench or
worktop with a maximum thickness of 60 mm.
• The height of the stand is adjustable.
Loosen the top tube of the stand by turning
it anticlockwise. Draw the tube out to its
maximum height and secure it by turning the
tube clockwise. The height of the suspension
bracket is adjustable by loosening the black
knob. After adjusting the suspension bracket
to the correct height, retighten the knob.
• Attach the Combitool to the suspension
bracket of the stand; this suspension bracket
can be turned 360°.
Accessories for the Combitool
Always check that the maximum rpm of the
accessory is suitable for the maximum speed of
the Combitool.
7
Publicidad
