Samsung harman/kardon HW-Q80R Manual página 13

2. Check the standby status of the Wireless Receiver Module after plugging it into an electrical outlet.
• The LINK LED indicator (blue LED) on the Wireless Receiver Module blinks. If the LED does not
blink, press the ID SET button on the back of the Wireless Receiver Module with a pen tip for
5~6 seconds until the LINK LED indicator blinks (in Blue). For more about the LED, please refer
to the SWA-9000S user manual.
3. Press and hold the Up button on the remote control for at least 5 seconds.
• The ID SET message appears on the display of the Soundbar for a moment, and then it
disappears.
• The Soundbar will automatically power on when ID SET is complete.
5 Sec
CAUTION
• If your Soundbar was playing music when it connects to the SWA-9000S, you may hear some
stuttering from the woofer as the connection finalises.
4. Check if the LINK LED is solid blue (connection complete).
STANDBY
STANDBY
LINK
5. If the SWA-9000S is not connected, repeat the procedure from Step 2.
SURROUND SPEAKERS OUT
SPEAKER IMPEDANCE : 3
L R
SURROUND SPEAKERS OUT
SPEAKER IMPEDANCE : 3
ID SET
POWER
POWER
"Samsung Harman Kardon" logo is on the top
LINK
Blue is On
5 Sec
ID SET
The LINK LED indicator stops blinking and
glows a solid blue when a connection is
established between the Soundbar and the
Wireless Receiver Module.
ENG - 9
STANDBY
LINK
STANDBY
LINK
Blue blinking
ID SET