Hart HLCS01 Manual Del Operador página 14

OPERATION
NOTE: Do not use dirty, used or otherwise
contaminated oils. Damage may occur to the
bar or chain.
 Carefully pour the bar and chain oil into the
tank.
 Check and fill the oil tank when battery is
recharged, or as needed.
NOTE: It is normal for lubricant to seep from the
saw when not in use. To prevent seepage, empty
the oil tank after each use. When storing the unit
for a long period of time (three months or longer)
be sure the chain is lightly lubricated; this will
prevent rust on the chain and bar sprocket.
NOTICE:
Before each use, check to make sure that the
chain is properly tensioned. A cold chain is
correctly tensioned when there is no slack on
the underside of the guide bar, the chain is
snug, and it can be turned by hand without
binding. During normal saw operation, the tem-
perature of the chain increases. The drive links
of a correctly tensioned warm chain will hang
approximately .050 in. out of the bar groove.
See the Adjusting the Chain Tension instruc-
tions in the Maintenance section of this manual
to properly adjust the chain tension.
STARTING AND STOPPING THE CHAIN SAW
See Figure 7.
WARNING:
Keep body to the left of the chain line. Never
straddle the saw or chain, or lean over past the
chain line. Improper operation of the chain saw
could result in serious personal injury.
Starting the chain saw:
 Slide and hold the lock-out button. This makes
the switch trigger operational.
 Press and hold the switch trigger, release the
lock-out button and continue to squeeze the
switch trigger for continued operation.
Stopping the chain saw:
 Release the switch trigger to stop the chain
saw.
 Upon release of the switch trigger, the lock-out
button will be automatically reset to the lock
position.
This cordless chain saw is designed for limbing
and pruning type cutting, as well as cutting small
trees.
PREPARATION FOR CUTTING
PROPER GRIP ON HANDLES
See Figures 8 - 10.
Refer to General Power Tool Safety Rules earlier
in this manual for appropriate safety equipment.
 Wear non-slip gloves for maximum grip and
protection.
 Hold the saw firmly with both hands. Always
keep your left hand on the front handle and your
right hand on the rear handle so that your body
is to the left of the chain line.
FIG. 7
FIG. 8
14 – English
LOCK-OUT
BUTTON
SWITCH
TRIGGER