Hart HLCS01 Manual Del Operador página 22

MAINTENANCE
WARNING:
Never touch or adjust the chain while the
motor is running. The saw chain is very sharp;
always wear protective gloves when performing
maintenance to the chain to avoid possible
serious lacerations.
CAUTION:
Always wear gloves when handling the bar and
chain; these components are sharp and may
contain burrs.
NOTE: When replacing the guide bar and chain,
always use the specified bar and chain listed in
the Bar and Chain Combinations section later
in this manual.
 R emove the battery pack before you do any
work on the chain saw.
 R emove the bar mounting nuts using the com-
bination wrench provided.
 R emove the chain cover.
 R emove the bar and chain from the mounting
surface.
 R emove the old chain from the bar.
 L ay out the new saw chain in a loop and
straighten any kinks. The cutters should face
in the direction of chain rotation. If they face
backwards, turn the loop over.
 P lace the chain drive links into the bar groove
as shown.
NOTE: Make certain of direction of chain.
 P osition the chain so there is a loop at the back
of the bar.
 Hold the chain in position on the bar and place
the loop around the sprocket.
 Fit the bar flush against the mounting surface
so that the bar studs are in the long slot of the
bar.
 Replace the chain cover ensuring that the ad-
justing pin in the chain cover is in the bar chain
tensioning pin hole and that both bar studs are
securely in their respective holes in the chain
cover.
NOTE: The adjusting pin may need to be slight-
ly repositioned with the chain tensioning screw
so that it is aligned with the position of the bar
chain tensioning pin hole.
FIG. 26
CUTTERS
FIG. 27
CHAIN DRIVE
LINKS
FIG. 28
CHAIN
TENSION PIN
HOLE
22 – English
CHAIN ROTATION
CHAIN DRIVE LINKS
BAR
GROOVE
BAR STUDS
ADJUSTING
PIN
CHAIN
COVER
BAR
MOUNTING
NUTS