Publicidad
Idiomas disponibles
Idiomas disponibles
Flexible Driver Attachment
·
Safety Rules for Flexible Driver
Do not operate the flexible shaft with a
sharp or multiple bends. Ensure that there
are no sharp residual bends or kinks in
the Flexible Driver before the operation.
Over bending the shaft can generate excessive
heat on the jacket or hand piece and may
cause the Flexible Driver to disengage from
the tool. The minimum recommended
bend radius is 6".
Always hold the hand piece firmly in your
hands during the start-up. The reaction
torque of the motor, as it accelerates to full
speed, can cause the shaft to twist.
Not for use with router bits or other large
diameters (1" or larger) bits. Large diame-
ter bits can cause kickback and loss of
control when used with the Flexible Driver.
Do not remove end ferrule while tool is
running. The cable will become loose from
the jacket and will uncontrollably whip or
lash around.
Installation Instructions
It is extremely important to carefully read and follow the directions below to
assemble the Flexible Driver to your rotary to ensure the tool will function
properly.
Do not pull out the center core to engage into driver cap. This could
shaft is bent, center core may be lodged in driver cap. Loosen shaft and
remove core from driver cap. Then screw Flexible Driver onto rotary tool
housing again.
1 Remove the shaft collar.
2 Loosen the collet nut.
- 15 -
6"RADIUS
Publicidad
