Publicidad
Idiomas disponibles
Idiomas disponibles
or serious injury.
NOTE List only those operations that are applicable.
NOTE List only those operations that were not included in the first warning.
If all listed operations are applicable, then this warning is omitted, but all
subsequent warnings are given without exclusion.
b)
Do not use accessories which are not specifically designed and recommended
by the tool manufacturer. Just because the accessory can be attached to
your power tool, it does not assure safe operation.
c)
The rated speed of the grinding accessories must be at least equal to the
maximum speed marked on the power tool. Grinding accessories running
faster than their rated speed can break and fly apart.
d)
The outside diameter and the thickness of your accessory must be within
the capacity rating of your power tool. Incorrectly sized accessories cannot
be adequately controlled.
e)
The arbour size of wheels, sanding drums or any other accessory must
properly fit the spindle or collet of the power tool. Accessories that do not
match the mounting hardware of the power tool will run out of balance,
vibrate excessively and may cause loss of control.
f)
Mandrel mounted wheels, sanding drums, cutters or other accessories
must be fully inserted into the collet or chuck. If the mandrel is insufficiently
held and / or the overhang of the wheel is too long, the mounted wheel
may become loose and be ejected at high velocity.
g)
Do not use a damaged accessory. Before each use inspect the accessory
such as abrasive wheels for chips and cracks, sanding drum for cracks,
tear or excess wear, wire brush for loose or cracked wires. If power tool
or accessory is dropped, inspect for damage or install an undamaged
accessory. After inspecting and installing an accessory, position yourself
and bystanders away from the plane of the rotating accessory and run
the power tool at maximum no-load speed for one minute.
Damaged accessories will normally break apart during this test time.
h)
Wear personal protective equipment. Depending on application, use face
shield, safety goggles or safety glasses. As appropriate, wear dust mask,
hearing protectors, gloves and workshop apron capable of stopping
small abrasive or workpiece fragments. The eye protection must be
capable of stopping flying debris generated by various operations. The
dust mask or respirator must be capable of filtrating particles generated
by your operation. Prolonged exposure to high intensity noise may cause
hearing loss.
i)
Keep bystanders a safe distance away from work area. Anyone entering
the work area must wear personal protective equipment. Fragments of
workpiece or of a broken accessory may fly away and cause injury beyond
immediate area of operation.
j)
Hold power tool by insulated gripping surfaces only, when performing an
operation where the cutting accessory may contact hidden wiring or its
own cord. Cutting accessory contacting a "live" wire may make exposed
- 03 -
Publicidad
