Descargar Imprimir esta página

EAS ELECTRIC EMD12W Manual De Instrucciones página 32

Publicidad

Idiomas disponibles

Idiomas disponibles

For detailed operating method read the corresponding content on the instruction manual.
Switch on the appliance
Fill the detergent dispenser
Check the rinse aid level
Check the regeneration
salt level
Load the baskets
Select a program
Running the dishwasher
Changing the program
Add forgotten dishes in the
dishwasher.
If the appliance is switched
off during a wash cycle.
Switch off the appliance
Turn off the water tap,
unload the baskets
2.Quick operation guide
2.Quick operation guide
Press the Power switch button to switch on the appliance, Open the door.
Compartment A:
Compartment A:
With each wash cycle.
Compartment B:
B:
For programs with pre-wash only.
(Follow the user instructions!)
Mechanical indicator C.
Mechanical indicator C.
Electric indicator on control panel (if provided).
(On models with water softener system only.)
Electric indicator on control panel (if provided).
If there is no salt warning light in the control panel
(for some models), you can estimate when to fill the salt into
the softener by the number of cycles the dishwasher has run.
Scrape off any large amount of leftover food. Soften remnants of burnt food in pans,
then load the baskets. Refer to the dishwasher loading instructions.
Close the door,press the program button until the selected program lights up.
( See the section entitled Operation instruction )
T urn on the water tap and press the Start/Pause button. The machine will start working .
1. A running cycle can only be modified if it has been running for a short ti m e. Otherwise the detergent
may have already been released and the water already drained. If this is the case, the detergent
dispenser must be refilled.
2. Press the Start/Pause button ,than press the program button more than 3 seconds to cancel the
running program.
3. Select a new program.
4. Restart the dishwasher.
1.Press the start/pause button to stop the machine.
2.Open the door.
3.Add the forgotten dishes.
4.Close the door, then press the start/pause button, the dishwasher will
start running again.
If the appliance is switched off during a wash cycle, when switched
on again, please re-select the washing cycle and operate the dishwasher
according to the original Power-on state ).
When the working cycle has finished, the buzzer of the
dishwasher will sound 8 times, then stop.
Turn off the appliance using the Power button.
Since the appliance is standing by, it will power off automaticly after 30 minutes without any operation.
Warning: wait a few minutes (about 15 minutes) before unloading the dishwasher to avoid handling
the dishes and utensils while they are still hot and more susceptible to break.
They will also dry better.Unload the appliance, starting from the lower basket.
4 4
B B
C C
A A
WARNING!
Open the door carefully.
Hot steam may escape
when the door is opened!
V.1

Publicidad

loading

Este manual también es adecuado para:

Emd12x