Publicidad
Idiomas disponibles
Idiomas disponibles
3.4
ON/OFF switch
The switch has two positions (Fig. 2 shows position 0).
y Position 0: Machine switched off
y Position I: Machine switched on
NOTE!
Always use the slide switch (Fig. 2) to turn the machine on and off.
Check the switch position before plugging in the cable.
3.5
Malfunctions
Overload protection switch (Fig. 5)
The overload circuit breaker protects the machine from impermissible me-
chanical and thermal stress. If the button of the overload protection switch
pops out (the machine stops), immediately switch off the machine addition-
ally with the slide switch (Fig. 2) (position = 0).
Reasons for the overload circuit breaker popping out are:
Defective motor, excessive clipping tension, blockage of the clipper head,
clogged air filter, etc.
Remedy the defect with the power plug disconnected. The machine can be
restarted after a few minutes by pressing in the overload protection switch
button.
For other malfunctions, see also Troubleshooting in chapter 5.2.
4
Maintenance
NOTE!
Before commencing any maintenance work disconnect the elec-
trical power supply by pulling out the plug.
Do not handle the area round the clipping blades as long as the
machine is still connected to a power source. Whenever working
on the clipping blades/clipper head, always first disconnect the
power supply.
4.1
Cleaning
Cleaning the clipper head and clipping blades
After finishing the clipping, remove oil from the machine by wiping with a
dry cloth and carefully clean the clipper head and clipping blades with a dry
brush. Then oil the parts to prevent rusting. Even the smallest rust spots on
the clipping blades impair clipping or make it completely impossible.
Translation of the original instructions / Clipper
13
Publicidad
