Publicidad
Idiomas disponibles
Idiomas disponibles
Mounting Precautions
(For SHARP dealers and service engineers)
• When installing, removing or moving the monitor, ensure that this is carried out by at least 4 people.
Be sure to use a wall-mount bracket designed or designated for mounting the monitor.
This monitor is designed to be installed on a concrete wall or pillar. Reinforced work m ight be necessary
for some materials such as plaster / thin plastic board / wood before starting installation.
• This monitor and bracket must be installed on a wall which can endure at least 4 times or more
the weight of the monitor.
• I nstall by the most suitable method for the material and the structure.
To attach a VESA-compliant mounting bracket, use M6 screws which are set-top-box for 55 inch and
65 inch models. Use M8 screws for 75 inch and 86 inch models.
For the screws, refer to the table shown below.
Sta ndard screws
Upper side
Length( Depth of
mounting holes)
Lower side
Qua ntity
For 4W-B55FT5U / 4W-B65FT5U
Do not use an impact d river.
• When moving the monitor, be sure to hold the a rea marked by
Do not grasp the screen . This may cause product damage, failure, or injury.
If you need to temporarily place the monitor on a table or other surface during installation,
spread a thick so cloth on the table to prevent damage to the screen and table.
After mounting, please carefully ensure the monitor is secure, and not able to come loose from
the wall or mount.
Do not use any screw holes other than those for mounting brackets, localed on the rear of the
monitor, for installation.
4W-B55FTSU and 4W-B65FTSU
M6 (1.0 pitch)
I
33 m m
I
10 m m
4 pcs. (set in the box)
*Longer screws (for Upper side)
*Shorter screws (for Lower side)
[4W-B55FT5U, 4W-B65FT5U, 4W-B75FT5U and 4W-B86FT5U]
9
4W-B75FTSU
4W-BS6FTS U
MS (1.25 pitch)
MS (1.25 pitch)
24 m m
30 m m
4 pcs.
4 pcs.
For 4W-B75FT5U /4W- B 8 6 F T 5 U
1 5/1 6 inch (24 m m ) / 1 - 1 1 /64(30 m m )
1,i
I �
Screws
Mounting bracket
(M8)
Monitor mounting
�
below.
□
Publicidad
