Publicidad
Idiomas disponibles
Idiomas disponibles
Certifications and Compliance
SUPPLIER'S DECLARATION OF CONFORMITY:
SHARP COMMERCIAL LCD TV, MODEL 4W-B55FT5U, 4W-B65FT5U,4W-B75FT5U , 4W-B86FT5U
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
RESPONSIBLE PARTY:
SHARP ELECTRONICS CORPORATION
100 Paragon Drive Suite #100 Montvale, NJ 07645 USA
For Business Customers: URL http://siica.sharpusa.com/
Wireless Radio
For product available in the USA/Canada market, only channel 1-11 can be operated. Selection of other channels is not
possible. This device is going to be operated in 2.412-2.462GHz frequency range.
The device could automatically discontinue transmission in case of absence of information to transmit, or
operational failure.
Note that this is not intended to prohibit transmission of control or signaling information or the use of repetitive
codes where required by the technology.
Important:
Any changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
FCC Radiation Exposure Statement:
uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the
radiator & your body.
IC Radiation Exposure Statement:
following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept interference recieved, including
interference that may cause undesired operation.
Industry Canada Statement
This Class A digital apparatus complies with CAN ICES-003(A)/NMB-3(A)
"Note to CATV system installer: This reminder is provided to call the CATV system installer's attention to Article 820 of the
National Electrical Code that provides guidelines for proper grounding and, in particular, specifies that the cable ground
shall be connected to the grounding system of the building, as close to the point of cable entry as practical."
NOTE
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment
is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instruction manual, may cause harmful interference to radio communica
tions. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will
be required to correct the interference at his own expense.
INFORMATION:
There is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an
This device complies with IC RSS-210 rules; Operation is subject to the
17
Publicidad
