Adventys GL2 1500 FLR Guia De Instalacion página 19

Air flow
Install a pipe diameter 100mm under the product and an air filter at the other side of the pipe, where
fresh air enter.
Connection to the generttor
TECHNICAL CONNECTION
In order to insert and connect each conductor in the terminal block:
1 /
Insert the end of a flat screwdriver to the right. The
maximum diameter of the rod must be 4mm.
1
Repeat the previous steps for each wire to be connected
Pipe for air flow
2 /
Then move the screwdriver to the right to al-
low the lowering of the spring-loaded jaw of the
terminal block contact.
2
Be careful not to push the wire end too far
into the jaw of the terminal block!!!
NO
!
YES
Page 19