Cameo G4 FC Manual De Usuario página 13

3
RJ45 INTERFACE
Interface for configuring and controlling the fixture using the Cameo UNICON DMX/RDM controller.
The fixture can also be configured using another RDM controller and controlled using a standard
DMX controller.
Pin assignment:
4 W-DMX RESET BUTTON
Button for disconnecting W-DMX connections and for pairing the spotlight with W-DMX devices.
The housing surface of the device can become very hot during regular operation. Always allow the
unit to cool down sufficiently before operating the button. Activate the fixture's W-DMX receiver
via Cameo UNICON and reset the receiver by pressing the button for about 3 seconds. All previous
connections are disconnected and the receiver is put into pairing standby for about 1 minute, the
status LED no. 5 flashes red quickly. The receiver is now waiting for a transmitter pairing request.
Start the pairing process on the transmitter; the pairing occurs automatically. In the same way,
several receivers can be paired to a transmitter either simultaneously or one after the other. A
W-DMX connection is always maintained until the connection is disconnected by means of the
Reset command in the receiver or the Unlink command in the transmitter, regardless of whether a
device has been disconnected from the power supply in the meantime.
5 STATUS LED
The LED shows the current status of the spotlight when controlled via cable and W-DMX.
13