Cameo G4 TW Manual De Usuario página 10

The operation of transmission systems is subject to official regulations. These may
vary from region to region and must be checked by the operator before use (e.g. radio
frequency and transmission power).
WARNING: Devices with wireless signal transmission are not suitable for use in sen-
sitive areas in which radio operation can lead to potential detrimental effects. These
include:
- Hospitals, health centres or other healthcare facilities that provide patient treatment
with skilled personnel and equipment.
- Hazardous areas Class I, II and III
- Restricted areas
- Military facilities
- Aircraft or vehicles
- Areas where the use of mobile phones is prohibited
TRANSMISSION VIA W-DMX
WARNING: In general, wireless DMX transmission must not be used for applications
involving safety-related factors that might result in personal injury or property dam-
age in the event of a failure.
This applies in particular to moving scene or traverse structures, DMX-controlled
motors/lifts or lifting devices for operating DMX-operated platform lifts, hydraulic
systems or comparable moving components.
Furthermore, wireless DMX transmission must not be used to trigger flame or pyro-
technic devices, explosion-driven effects, or to control gas or liquid effects. These
include CO2 cannons, confetti shooters, water effects or similar.
AMBIENT TEMPERATURE
Please observe the maximum ambient temperature in operation specified in the tech-
nical data. A special protection circuit in the headlamp ensures that the brightness
is reduced if the ambient temperature is too high to protect the unit components. If
you notice a significant loss of brightness in the headlamp, please check the ambient
temperature in the direct vicinity of the headlamp and, if necessary, ensure that the
temperature is brought to or below the maximum permitted value.
INSTRUCTIONS FOR INDOOR INSTALLATION EQUIPMENT
1. Equipment for installation applications is designed for continuous operation.
2. Equipment for indoor installation is not weather-resistant.
3. Surfaces and plastic parts can also age in installation equipment, e.g. due to UV ir-
radiation and temperature fluctuations. This generally does not impair functionality.
10