Publicidad
Idiomas disponibles
Idiomas disponibles
Measurements are taken from the rear edge 10 of the tool as
indicated by
After the measuring tool is switched on, continuous
measurement starts. Aim the laser beam at the target surface.
The current measuring value d is displayed on the display (see
figure A). During continuous measurement, the measuring
tool can be moved relative to the target, whereby the current
measuring value d is updated approx. every 0.5 seconds on the
display (see figure B).
In this manner,as an example, you can move a certain distance
away from a wall, while the actual distance can always be read.
The laser indicator
For a wall to wall measurement, as an example, position the
measuring tool with its rear edge against the initial wall.
160992A6EZ GLM100-23 202210.indd 15
Measuring Procedure
icon located on the keypad.
flashes on the display.
No Measurement Being Displayed
All dashes will display when the beam is
moved too fast or if the object is out of
range in continuous mode.
"HOLD" Function (see Figure B)
Press the "On/Off (measuring)" button 1 to
stop the measuring procedure. The laser
beam is switched off and the last
measurement is frozen on the display and
the status bar slides from top into the
screen.
-15-
10/4/22 10:19 AM
Publicidad
