Publicidad
Idiomas disponibles
Idiomas disponibles
LED INDICATOR
Short green flash
Long green flash
Solid green
The following LED codes indicate an error condition of the charger. For details on how to clear the error, refer to the steps
in the Troubleshooting section at the end of this manual.
Red light turns on briefly then goes out Check for valid AC voltage to charger.
One red flash
Two red flashes
Three red flashes
Four red flashes
Five red flashes
Six red flashes
NOTICE:
Always turn power switch to OFF position and remove
key when charging mower and when mower is not in use.
NOTICE:
Always connect the mower to the charger when the unit is
not in use. If it is not possible to leave the mower charger
connected, make sure to charge the batteries fully at least
once a month.
SAFETY INTERLOCK SYSTEM
See Figure 9.
This mower features a Safety Interlock System to protect the
operator by shutting off the blades if the operator leaves the
seat with the blades running. Test the system before each
use to be sure it is working correctly.
To test:
Position the mower on a level surface.
Make sure direction control switch is in neutral (N) position
and blade engage knob is down.
Install start key and turn to ON position.
Raise blade engage knob to activate blades.
Briefly lift off the seat, but do not get off the mower.
The blades should shut off within 5 seconds. If they don't,
contact customer service. Do not operate the mower until the
safety interlock system has been repaired.
OPERATING THE MOWER
See Figures 9 - 11.
WARNING:
Clear the area of bystanders before operating the mower. If
anyone enters the mowing area, stop immediately and do
not return to mowing until the bystanders leave the area.
OPERATION
BATTERY/CHARGER STATUS
Batteries are less than 80% charged.
Batteries are more than 80% charged.
Batteries are fully charged.
Charge Enable Fault
Battery Voltage Fault
Battery Charge Timeout: Charge Time Exceeded
Battery Fault: Charge Time Exceeded
Temperature Delay
Charger Fault
Before starting the mower:
Ensure work area is clear of children, bystanders, and pets.
Clear the work area of objects that may be thrown by the
Check brake operation.
Check tire pressure.
Check for loose fasteners.
Check to make sure all guards are in place and working
Clean debris from mower.
Test safety interlock system.
Adjust seat to desired position.
Verify battery charge level.
16 — English
mower blades.
properly.
Fig. 9
Publicidad
